Thermostat 230V ZFX ST3012

Thermostat 230V ZFX ST3012 - description

PARAMETERS AND FEATURES OF PRODUCT These are two independent thermostats with separate sensors in one controller. The regulator is designed for automatic temperature control in two places and devices. Simple and intuitive operation. The device has a built-in memory for settings. When the thermostat's power supply is disconnected, there is no need to reprogram it. Well-visible LED diodes signaling the activated relay and triggered alarm. The device has an alarm for exceeding the lower or upper temperature limit. The alarm is signaled by sound as well as by the display plus a blinking signaling diode. Input voltage (power supply): AC 230V, the thermostat does not require external power. Contact load of the relay: 5A at AC 230V Temperature measurement: -50°C - +110°C Temperature measurement resolution: 0.1°C Temperature refresh rate: 0.5s (very fast) Temperature measurement probe: waterproof (stainless steel) Used sensor: NTC10k/343S Length of the cable with the probe: 95cm (longer ones are available in our offer). Length of other cables: about 20cm Probe diameter: 4mm Probe length: 20mm Displays: 2x LED 3 digits Display color: red Color of signaling LED: green/red (relay/alarm) Dimensions of the housing without mountings: 76 x 55 x 31mm Mounting hole spacing: 88mm Operating temperature: 0°C - 50°C Weight: 100g Description of outputs and user manual below in graphics. User manual Thermostat 2 (buttons "up" and "down" under the right display) is programmed analogously as thermostat 1 (buttons "up" and "down" under the left display). Setting the temperature of thermostat 1: Press SET once, then use the "up" and "down" buttons to set the temperature (holding the button speeds up the temperature change). Setting the temperature of thermostat 2: Press SET twice, then use the "up" and "down" buttons to set the temperature (holding the button speeds up the temperature change). MENU of thermostat 1: Press SET once, then hold SET for 2 seconds to enter the MENU. MENU of thermostat 2: Press SET twice, then hold SET for 2 seconds to enter the MENU. Using the "up" and "down" buttons, select one of several functions available in the MENU. MENU (in parentheses the setting ranges): HC - Heating "H" / Cooling "C". D - difference °C between the set temperature and relay turn-on temperature (1-30°C). LS - low temperature alarm (from -50°C to +109°C). Alarm signaled by sound, blinking red LED and display "-L-". HS - high temperature alarm (from -49°C to +110°C). Alarm signaled by sound, blinking red LED and display "-H-". CA - correction (calibration) of temperature readings (from -10°C to 10°C). PT - delay in relay activation (0-10min) Press SET to select the appropriate function, then use "up" and "down" to change the value. Press SET to return to function selection. Always after 5 seconds of inactivity (regardless of where in the MENU), the device saves the settings and returns to displaying the temperature. The blinking red LED indicates the countdown of the delay time PT.

---

Payment options

• Bank transfer

---

Delivery options

• National delivery
• International delivery

---

Shipping to countries